November 5, 2019

F5 Tuning

I’ll try to add to this post some of the F5 tuning settings you can configure for specific tasks.
November 5, 2019

F5 Redis Load Balancing Settings

I’m not going to go into too much detail but I just want to point out redis specific configs. Redis sentinal uses a master slave setup. […]
November 5, 2019

Palo Alto Routing Verification Basics

November 4, 2019

Palo Alto User-ID Ignore List Notes

There are times you’ll want to create an ignore list on the Palo Alto. Basically what this is doing it telling the Palo Alto FW to […]
November 1, 2019

Using iperf3 to Help Troubleshoot Speed and Throughput Issues

There are many cool options you can use with iperf but I think it’s important to use multiple simultaneous streams. I’ve seen people use this tool […]
August 15, 2019

Dasan Zhone Commands

July 22, 2019

Splunk Queries

Here’s a short list but I plan on added more in the near future.
July 5, 2019

Cisco ASA Syslog Messages

Alert Messages, Severity 1 Critical Messages, Severity 2 Error Messages, Severity 3 Warning Messages, Severity 4 Notification Messages, Severity 5 Informational Messages, Severity 6 Debugging Messages, […]
July 5, 2019

Cisco ASA Threat Detection

*Do not just implement this into a production environment. If can, test this in test environment first. Basic threat detection is enabled by default on all […]
July 5, 2019

Microsoft Windows Net Use Command

Sometimes people forget that you don’t need to use a drive letter when using the “net use” command. Also it’s good to use the command below […]
July 3, 2019

Palo Alto Cheat Sheet – VSYS

Find out if the firewall is in multi-vsys mode
July 3, 2019

Palo Alto Cheat Sheet – Panorama

July 3, 2019

Palo Alto Cheat Sheet – User-ID

View all User-ID agents configured to send user mappings to the Palo Alto Networks device:
July 3, 2019

Palo Alto Cheat Sheet – Device Management

Show general system health information. > show system info
July 3, 2019

Palo Alto Cheat Sheet – Networking

General Routing Commands